显微镜物镜加热器 OBJECTIVE HEATER 

Features

Temperature controlled heating band
Easy installation around the objective
Fits any objective on the market
Compatible with the following OKOLAB Controllers:
H301-T-UNIT-BL-PLUS
UNO-T-H-PREMIXED
UNO-T-H-CO2
H401-T-CONTROLLER
Compatible with Inverted and Upright Microscopes
Self CalibrationRoutines with BL controllers
Voltage24 V
Power13 W

When should I use an Objective Heater
You should use an objective heater, if you:

Perform Oil Immersion Imaging with a Top Stage Incubator
Use dipping lens with an upright Top Stage Incubator
Why should I use an Objective Heater?
Because, if you don't, sample temperature will drop due to oil contact with the cold objective, as shown in the following graph.

Step 1Objective not in contact with Petri 2; Objective Heater Off.

Step 2Objective in oil contact with Petri 2; Objective Heater Off.

Step 3Objective in oil contact with Petri 2; Objective Heater on, Offset value 5.3°C.

During the self calibration routine, the offset value of the objective heater is progressively increased, until T2 reaches the desired set point temperature of 37.0°C.

Figure 3 reports the profile of T1, T2, and of Objective Heater Temperature during the experimental campaign described above.